Chevy crate 350 with 375 HP engine package was designed for you mild performance corvette lovers.  Just check out the quality of parts listed below. This performance engine can be custom designed to tailor to your specific needs. We can also custom paint your engine to match your vehicle at your request. We are a dealer for March Performance serpentine belt systems if you choose them as your pulley manufacture.  We can also assist you in choosing the proper transmission and stall speed converter combination for your vehicle and have it shipped directly to you as your performance crate engine is being built.

• Seasoned factory roller 4 bolt main block 1 or 2 pc rear main seal
• Bored and honed .030 with deck plate
• Mains have been aline honed
• Block as been decked .020
• Dura Bond bearing installed
• Brass freeze plug and oil galley kit installed
• Block painted with 3 coats of high temp ceramic engine paint customers choice of color
• New Scat Cast steel crankshaft
• New Scat I-Beam connecting rods with ARP bolts
• Speed-Pro or Keith Black pistons (9.5:1 compression when used with 64cc head and standard .041 thick head gasket)
• Clevite P Series rod and main bearing
• Hastings cast rings hand filed to match application
• The complete rotating assembly will be balanced

             Only $1,735

• All The Above Plus The Following:
• Three piece true double roller timing set
• Custom ground performance camshaft to achieve the idle & throttle response to customer’s desire
• (16) New high rev lifters (anti-pump up)
• PBM performance aluminum cylinder heads 64cc with 200cc intake runners
• (8) Stainless steel 2.02 intake valves
• (8) Stainless steel 1.60 exhaust valves
• (16) High performance valve springs and retainers (to match camshaft)
• 3/8 screw in studs and hardened guide plates 
• (16) Chrome Moly push rods
• (16) Performance roller tip rockers
• Engine will be assembled with all new bolts
• High volume oil pump and screen
• Chrome oil pan
• Chrome dip stick and tube
• Chrome timing cover
• Fel-Pro performance gaskets

        Only $4,200

• All The Above Plus The Following:
• Professional products performance balancer
• Edelbrock aluminum Performer RPM intake manifold
• Chrome thermostat housing
• Edelbrock carburetor w/ electric choke (upgrade to a Holley for $300)
• 14" Chrome air cleaner
• MSD HEI Distributor W/53,000 Volt Coil (Good For Up To 6500 RPM)
• (8) Autolite spark plugs
• Custom fit Taylor 8mm ignition wires (color of choice black, red, blue, yellow, green, orange no extra charge) 
• High flow cast iron water pump
• Chrome valve covers
• Chrome breather
• Complete PCV ventilation system
• All engines will come with starter and flex plate (for auto trans), additional $200 for manual transmissions
• Engines are photo documented during the building process so you can see the quality of parts and workmanship that goes into your engine
• Each engine is live run tested, timing set and carburetor adjusted for optimum performance
• We video tape your live run engine and send you a copy
• All of our turnkey engines come with a 1 year warranty with unlimited mileage

       Only $5,300

- Polished Oil Pan
- Polished Timing Cover
- Polished Ball Milled Valve Covers
- Polished Edelbrock Intake Manifold
- Polished Edelbrock Water Pump
- Polished Billet Ball Milled Wire Looms
- Edelbrock Endura Shine Carburetor
- Polished Air Cleaner

Add $1,050